Headlight Aiming Adjustment - Hyundai XG350 2005 Owner's Manual

HEADLIGHT AIMING ADJUSTMENT

G290A03L-AAT
HID Type (If Installed)
!
WARNING:
If you need headlight aiming adjustment,
have your vehicle inspected by your Hyundai
Dealer.
Don't attempt to replace or inspect the HID
headlight bulb to prevent danger of an
electric shock.
General Type
Vertical
aiming
Before performing aiming adjustment, make
sure of the following.
1. Keep all tires inflated to the correct pressure.
2. Place the vehicle on level ground and press
the front bumper & rear bumper down sev-
eral times. Place vehicle at a distance of 118
in. (3m) from the test wall.
3. See that the vehicle is unloaded (except for
full levels of coolant, engine oil and fuel, and
spare tire, jack, and tools). Have the driver
or equivalent weight placed in driver's seat.
4. Clean the head light lenses and turn on the
headlights (Low beam).
5. Open the hood.
6. Draw the vertical line (through the center of
each headlight) and the horizontal line
(through the center of each headlight) on the
aiming screen.
And then, draw a parallel line at 0.8in.(21mm.)
under the horizontal line.
7. Adjust each cut-off line of the low beam to the
parallel line with a phillips screwdriver -
VERTICAL AIMING
!
WARNING:
Horizontal aiming should be adjusted by an
authorized Hyundai Dealer.
G290A02L-A
DO-IT-YOURSELF MAINTENANCE
G290B02L-AAT
Adjustment After Headlight Assembly
Replacement
0.83 in. (21 mm)
Horizontal line
Cut-off line
H L
If the vehicle has had front body repair and the
headlight assembly has been replaced, the
headlight aiming should be checked using an
aiming screen as shown in the illustration. Turn
on the headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustration.
2. Dotted lines in the illustration show center of
headlights.
6
21
Vertical line
W
"P"
H
Ground
line
G290B01L-A