KTM 450 SX-F Repair Manual page 84

6-13
3
5
3
8
2
4
0,7 mm
7
6
– Remove the engine locking screw
– Insert the screw with the copper washer and tighten to 20 Nm.
2
Mounting the pulse generator
– Degrease the thread on the screws
– Screw on the pre-assembled pulse generator and holder by hand. Do
not tighten the screws yet.
– Turn the crankshaft until the contact piece on the rotor aligns with
the pulse generator.
– Adjust the distance between the rotor contact piece and the pulse
generator to 0.7 mm and tighten the screws to 6 Nm.
– Thread in the pulse generator cable and press the cable support
sleeve into the engine case.
4
– Degrease the thread on the screw
on the retaining bracket and tighten to 10 Nm.
Mounting the starter drive
– Oil all of the bearings.
– Mount the starter idler gear
– Insert the torque limiter
7
Mounting the ignition cover
– Make sure the needle rollers
– Degrease the sealing area mount a new ignition cover gasket.
– Degrease the sealing area on the ignition cover.
– Mount the pre-assembled ignition cover.
– Insert the ignition cover screws and tighten to 10 Nm.
.
1
and apply Loctite 243.
3
and apply Loctite 243. Screw
5
.
6
.
are in place.
8