KTM 450 SX-F Repair Manual page 82

6-11
2
1
3
7
LOCTITE 243
5
4
6
8
9
Mounting the clutch
– Mount the collar sleeve
1
hub .
3
NOTE: make sure the toothing engages in the oil pump idler gear.
– Mount the stop disk and driver
– Degrease the thread on the main shaft and apply Loctite 243.
– Mount a new lock washer and screw on the drive nut.
– Hold the driver with clutch holder 773.29.003.000 while you
tighten the drive nut to 80 Nm.
– Lock the drive nut with the lock washer.
– Thoroughly oil all lining disks.
– Starting with a lining disk
clutch disks in the outer clutch hub, ending with a lining disk on
6
top.
– Insert the oiled pushrod
clutch .
– Insert the pressure piece
– Mount the pressure cap
9
– Tighten the screws on the pressure cap with washers and springs in
stages in a crosswise direction to 10 Nm.
, oiled needle bearing and outer clutch
2
.
4
insert all 9 lining disks and all 8
5
with the shorter stepping facing the
7
.
8
.