KTM 450 SX-F Repair Manual page 75

A
A
1
3
2
5
6
Mounting the oil pump
– Mount the suction oil pump with the oil pump shaft and oiled
needle roller.
NOTE:
– The rounded side
B
case.
– The groove
engine.
– Degrease the thread on the oil pump cover screws and apply Loctite
243. Screw on the oil pump cover with mark
tighten to 6 Nm.
– Insert the needle roller
– Mount the oil pump gear and shim. Mount the lock washer
– Mount the oiled needle bearing, oil pump idler gear and shim.
Mount the lock washer
– Insert the needle roller for the suction oil pump drive in the oil
pump shaft.
– Mount the oiled suction oil pump.
NOTE: the rounded side of the suction oil pump should face the engine
4
case.
– Insert the needle roller
– Mount the pre-assembled oil pump housing including the gasket.
– Insert the needle roller
– Make sure the needle rollers
of the suction oil pump should face the engine
A
in the oil pump shaft should face the right side of the
B
.
1
.
3
.
4
.
5
are in place.
6
6-4
facing up and
A
.
2