2-5
2
4
Checking the oil level of the hydraulic clutch
1
O
NLY FILL
F
LUID
NOTE: remove the cover to check the oil level in the master cylinder of
the clutch.
3
– Move the master cylinder into a horizontal position.
– Remove the screws
boot
– The oil level should be 4 mm under the upper edge with the master
cylinder in a horizontal position. If necessary, add SAE 10
biodegradable hydraulic oil (e.g. Motorex Hydraulic Fluid 75).
– Remount the rubber boot, cover and screws.
Bleeding of the hydraulic clutch
O
NLY FILL
F
LUID
– Move the master cylinder into a horizontal position.
– Remove the screws
boot
– Remove the bleeder screw on the slave cylinder of the clutch and
mount the bleeding syringe
hydraulic oil (e.g. Motorex Hydraulic Fluid 75).
– Press the SAE 10 biodegradable hydraulic oil into the system until
oil starts to run out of the hole
bubbles. Make sure the oil does not overflow.
– After bleeding the clutch, remove the bleeding syringe and mount
the bleeder screw.
– Add SAE 10 biodegradable hydraulic oil (e.g. Motorex Hydraulic
Fluid 75) up to 4 mm under the upper edge.
– Remount the rubber boot, cover and screws.
A
Adjusting the throttle cables
– Push back the dust boots.
– Set 3-5 mm free travel at the throttle grip with the adjusting screw
5
the handlebar is turned all the way to the left or right.
– Slip on the dust boots.
– Check the throttle grip for smooth operation.
5
!
CAUTION
SAE 10
BIODEGRADABLE HYDRAULIC OIL
75)
INTO THE MASTER CYLINDER
and the cover
1
.
3
!
CAUTION
SAE 10
BIODEGRADABLE HYDRAULIC OIL
75)
INTO THE MASTER CYLINDER
and the cover
1
.
3
. The idling speed should not change with the engine running if
!
(
.
. M
E
G
OTOREX
. D
.
O NOT ADD BRAKE FLUID
together with the rubber
2
!
(
.
. M
E
G
OTOREX
. D
.
O NOT ADD BRAKE FLUID
together with the rubber
2
filled with SAE 10 biodegradable
4
in the master cylinder without
A
H
YDRAULIC
H
YDRAULIC