Network Settings - Bosch VIP X1 Installation And Operating Manual

EN | 42

Network settings

Here, you can specify network addresses and configure multiple connections.
Network
The settings on this page are used to integrate the unit into an existing network.
Warning!
Changes to the IP address, subnet mask or gateway address are
transferred to the unit by clicking Set. However, they only take effect after
the unit is restarted.
– Click Set after entering a new IP address.
– To do this, enter the old IP address followed by /reset (for instance
192.168.0.111/reset) in the address bar of your web browser. The
VIP X will be restarted, after which it can only be accessed at the new IP
address.
Unit IP address:
Enter the desired IP address for the VIP X in this field. The IP address must be
valid for the network.
Subnet mask:
Enter the appropriate subnet mask for the set IP address here.
Configuration using a Web Browser
Installation and Operating Manual | VIP X1/VIP X2
Bosch Security Systems | 2005-10 | V1.5