Troubleshooting - Bosch VIP X1 Installation And Operating Manual

VIP X1/VIP X2 | Installation and Operating Manual
Appendix

Troubleshooting

If you cannot resolve a fault, please contact your supplier or system integrator
or go direct to Bosch Security Systems Customer Service.
The version numbers of the internal processors can be viewed on a special
page. Please note this information before contacting Customer Service.
– In the address bar of your browser, after the unit IP address enter
/version.htm (for example 192.168.0.111/version.htm).
– Write down the information or print out the page.
The following table is intended to help you identify the causes of malfunctions
and correct them where possible.
Malfunction
No connection
between the unit and
terminal program.
No image
transmission to
remote location.
Bosch Security Systems | 2005-10 | V1.5
Possible causes
Incorrect cable connections. Check all cables, plugs, contacts,
The computer's serial
interface is not connected.
Interface parameters do not
match.
Defective camera.
Faulty cable connections.
Solution
terminals and connections.
Check the other serial interfaces.
Select a different interface if
necessary and make sure that the
computer's interface parameters
match those of the unit. If
necessary try the following
standard parameters: 19,200
baud, 8 data bits, no parity, 1 stop
bit. Then disconnect the unit from
the mains and reconnect it again
after a few seconds.
Connect a local monitor to the
camera and check the camera
function.
Check all cables, plugs, contacts
and connections.
EN | 103
8
Appendix