Bosch VIP X1 Installation And Operating Manual page 41

VIP X1/VIP X2 | Installation and Operating Manual
Number of destination IP address:
Here you assign the numbering for the IP addresses to be contacted in the event
of an alarm. The unit contacts the remote locations one after the other in the
numbered sequence until a connection has been established.
Destination IP address:
For each number, enter the corresponding IP address for the desired remote
location.
Destination password:
If the remote location is password protected, enter the password here.
Auto-connect:
Select On if an active connection should be re-established automatically to one
of the previously specified IP addresses after each restart, connection
breakdown or network failure.
Note
For automatic connections, always Stream 2 is transmitted. Take this into
account when assigning the profile (see page 31).
Include audio: (audio versions only)
Select the option On if you wish to additionally transmit a separate G.711
encoded audio stream with alarm connections.
Note
Audio signals are only transmitted if the audio function is enabled (see
page 61) in the Audio settings configuration screen.
Default camera: (VIP X2 only)
Here you can select the camera whose image will be automatically displayed
first on the receiver when the alarm connection is made. Depending on the
system configuration, the receiver can then select the other cameras as well.
Note
The numbering follows the identification of the video inputs on the device.
Bosch Security Systems | 2005-10 | V1.5
EN | 41
Configuration using a Web Browser