Unpacking The Projector; Projector Configuration - Christie RPMSP-500Xe 38-GFX208-xx Installation Manual

RPMSP Series Installation Guide
2. Unpacking
the Projector
3. Projector
Configuration
For RPMSP-500Xe
2
The projector is carefully packaged in a way as to protect it from any unnecessary
shipping damage.
When unpacking the projector:
•
Remove all packaging material from around the projector. Make sure
all vents are clear and no scrap pieces of material are lying in between
modules.
•
Check cable connections to ensure not became loose during shipment.
Refer to Table 1. for your specific projector model if cables need to be
reconnected.
Table 1. Cable Connections
'
D100U models
Electronics Module
J91
J94
'
500Xe models
Electronics Module
J91
J94
The projector can be configured in two ways: with the lens at 0° (lens horizontal) or
90° (lens vertical). The latter is typically used in installations where a first surface
optical mirror is used. Refer to the instructions for your specific model to change the
configuration, if necessary.
Projector must be powered down and unplugged
before performing any setup or service procedure.
'
NOTE: You will need the two brackets shipped with the projector, to change the
projector's configuration from lens horizontal to lens vertical.
1. Disconnect cable connections made to the PHM.
2. Remove the lamp. See User's Manual for instructions.
Projection Head Module
→
J90
→
J89
P114
Projection Head Module
→
J90
→
J89
J88
WARNING
Dual Lamp Module
→
P115
Ballast Module
J102 to P103