Table of Contents
Advertisement
7. Loosen the single hex screw on the connector between the PHM and DLM.
Figure 13.
8. Turn the DLM module 15 degrees counter-clockwise and gently pull the two
modules apart. Set the DLM back down in the horizontal position. Figure 14.
Keep the DLM module in a horizontal position.
9. Flip the PHM 90 degrees (lens pointing up) and remount it over the DLM
connector. Tighten the hex screw on the connector to secure both modules
together. Figure 15.
10. Replace the louvered side panels removed in Step 6.
11. Remove the PHM mounting bracket from the adjuster – 2 screws. (The DLM
mounting bracket remains the same.) Figure 16.
12. Place the mounting bracket shipped with the projector for 90-degree
configuration over the mounting holes on the adjuster. Figure 16.
13. Secure bracket in place with 2 screws (provided with projector). Figure 16.
14. Unscrew the 2 wing nuts on the PHM module.
15. Re-install the wing nuts in two vacant mounting holes on the PHM–see Figure
16.
RPMSP Series Installation Guide
Figure 13.
Figure 14.
Figure 15.
7
Advertisement
Table of Contents
