Table of Contents
Advertisement
7.
Software Setup
Guide for First
Time
Installations
Most installations require some kind of software setup to optimize settings so the
projector displays the brightest and sharpest image(s). Use the following step-by-step
guide together with the User's Manual for first time software setup. The User's
Manual describes in detail how to access and change projector software settings.
Unless otherwise indicated, instructions apply to all projector models in stand-alone
or multi-projector configurations.
1. Display an external signal.
2. For D100U models only, select a Lamp Operation mode from the Lamp menu.
Perform all setups in this mode.
3. Assign projector ID number(s).
4. Select Image Orientation in the Configuration menu and to change the
orientation of the displayed image to suit the installation. For example in rear
screen installations select "rear" from the pull down list for the image to display
correctly from the audiences perspective.
5. Modify Language and any settings in Menu Preferences to suit your needs.
6. Enable Broadcast Key in the Communications menu – this enables you to switch
between communicating with one or all projectors.
7. Select Auto Setup, to give the projector a chance to setup the best possible
settings for the chosen incoming signal.
8. Verify Processing Mode in Image Settings is correct for the chosen signal.
9. Change Resize Presets if you want the image displayed at any other resolution
other than native.
10. Adjust Pixel Phase and Pixel Tracking to eliminate any noise in the displayed
image – accessible from the Size and Position menu.
RPMSP Series Installation Guide
Figure 19.
11
Advertisement
Table of Contents
