Christie RPMSP-500Xe 38-GFX208-xx Installation Manual page 6

RPMSP Series Installation Guide
For RPMSP-D100U
6
Uncovered slots
allow light to pass
through
'
NOTE: When changing the configuration of the D100U projector you must also
change the position of the adjuster on the bottom mounting plate, as well as install a
new PHM mounting bracket to suit the new orientation of the optical unit.
1. Assuming the projector is off and unplugged, disconnect all cable connections
made to the PHM and DLM.
2. Loosen the captive screws securing the PHM and DLM assembly to the adjuster
mounting brackets. Figure 11.
3. Lift the PHM/DLM assembly off the adjuster and set aside.
4. Tilt the mounting rails to access the 4 screws securing the adjuster to the bottom
mounting plate. Remove adjuster.
5. Align the adjuster with mounting holes on the plate labeled "C" (stands for cube
configuration). Secure with the 4 screws removed the step earlier.
6. Remove the louvered side panels on the DLM.
Projection
Head
Module
Figure 10. Cover slots in PHM
Figure 11.
Figure 12.
Slots covered