Base Setup And Operation; Rover Setup - Magellan ProMark3 RTK Getting Started Manual

Allowing for kinematic ini-
tialization using Initializer
bar at the base
1.

Base Setup and Operation

The base is setup and operated in the same way as it is in stat-
ic surveys (see page 43). The only difference is the use of the
initializer bar at the base station.
The base antenna should be centered and levelled above the
known point. To be able to use the initializer bar for initializa-
tion, be sure to incorporate the bar as part of the base setup
as shown opposite.

Rover Setup

Install the unit on its range pole:
1. Attach the field bracket onto the pole.
2. Place the ProMark3 receiver into the field
bracket.
3. Connect the GNSS antenna cable to the unit.
4. Mount the GNSS antenna at the end of the
base's initializer bar.
5. Connect the other end of the antenna cable to
the rover antenna.
4.
5.
3.
2.
47