Glass Frame Assembly / Screen Front; Installation; Approved Venting; Combustion Air Venting Options - kozy heat MPS-30 Minneapolis Installation Manual

GLASS FRAME / SCREEN FRONT
DO NOT OPERATE THIS FIREPLACE WITH GLASS REMOVED, CRACKED OR BROKEN. REPLACEMENT OF GLASS FRAME
ASSEMBLY, #JOR-057T SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON.
WARNING
DO NOT REMOVE THESE COMPONENTS WHEN HOT!
REMOVE GLASS FRAME ASSEMBLY
A. Locate spring-loaded latches securing glass frame assembly at bottom of firebox.
B. Using glass latch tool (included in components packet) pull bottom latches out and up to
release glass frame assembly latch tabs.
C. Lift glass frame assembly up off tabs located at top of firebox.
INSTALL GLASS FRAME ASSEMBLY
A. Make certain bottom latches are pushed down to allow for easier installation.
B. Align slots at top of glass frame assembly over tabs at top of firebox while lowering
bottom of glass frame assembly into position.
C. Using glass latch tool, pull latches out and down over latch tabs to secure glass frame
assembly bottom.
SCREEN FRONT
(sold separately)
To install: Align tabs on back of frame with slots on insert, set into position.
To remove: Lift frame up and out of slots.
All steps as outlined in 'PREPARE EXISTING FIREPLACE' must be completed before continuing with this installation.
ATTENTION
Follow instructions from vent pipe manufacturer as well as venting requirements as outlined in this installation manual.

APPROVED VENTING

MANUFACTURER
Kozy Heat
ICC
Selkirk
American Metals
Simpson Dura-Vent
Security
Metal Fab
RLH

COMBUSTION AIR VENTING OPTIONS

OPTION 1: FULL CONNECTION: Combustion air intake pipe is run entire chimney length and connected to termination cap.
OPTION 2: STUB VENTING: Combustion air intake pipe is extended a minimum of 4ft. (1.22m) past damper opening into

INSTALLATION

APPROVED CAPS
816-CL Vent System
TM-IVT
TM-SVT
4DT-VC
4DVC
46DVA-VCH
3PDVCV
4DVT
HS-C33U99
HS-C33F1313
HS-CD3333-1313
existing chimney. It is not connected to termination cap.
10
Upper tab (1 ea. side)
Lower latch (1 ea. side)
Latch tab
Insert glass latch tool here
Figure 10a