Robot Start Without Perimeter Wire - AMBROGIO BASIC User Manual

ROBOT START WITHOUT PERIMETER WIRE

This mode can be carried out with
the remote control to perform the
trimming of areas completely
marked by fences or to trim, for
example, small areas, where it
was not possible to mark or for
practical demonstrations on the
functioning of the robot
Important
When the robot is used without
the perimeter wire, it is recom-
mended to make sure that the
robot does not hit into obstacles,
corners or blunt objects so to avoid
damages or breaks.
1-Press key ON (A).
2-Insert the password (if requested)
(see "Enter password").
The following mes-
sage appears of the
display:
3-Press the key "En-
ter" until displaying "Perimeter" (see
"Programming mode").
The following mes-
sage appears of the
display:
4-Press one of the
keys "+", "-" to set "NO".
5-Press the key "En-
ter" to confirm
the selection.
Key "ON" (A)
Key "Off/Stop" (C)
6-Press the key "Start/Pause" (B)
twice consecutively to start the robot
7-Manoeuvre the robot with the tele-
command (see "Remote control de-
scription").
Important
It is advisable to operate the robot with
the remote control to carry out the
trimming inside a narrow area, well vis-
ible and to avoid, if possible, making it
hit into obstacles.
8-Having finished mowing, press the
key "Off/Stop" (C) to stop the robot
in safely (see "Robot safety stop").
Important
If the antitheft alarm is enabled, disen-
able it before lifting the robot (see
"Programming mode").
9-Position the robot inside the recharg-
ing station.
- 41 -
Key "Start/Pause" (B)
IDM - 41501710200.tif
User's manual
GB