AMBROGIO BASIC User Manual page 52

GB
Problem Causes
Insufficient work hours
Cutting blade with deposi-
ts and/or residues
The working area
Cutting blade worn out
is not completely
trimmed
Working area too big
compared to the actual
capacity of the robot.
Batteries are about to
deplete their life cycle.
The batteries do not re-
charge completely.
Secondary area
not completely Wrong programming
mown
The perimeter wire is not
On the display "No correctly connected (bro-
Signal" appears. ken wire, lack of electric
connection, etc.).
Solutions
Extend the work timetable
(see "Programming mode")
Stop the robot in safety condi-
tions (see "Robot safety stop")
Use protection gloves to
avoid the risk of cuts on
hands.
Clean the cutting blade
Replace the blade with an ori-
ginal spare part (see "Replace
the blade")
Ad just the working area (see
"Specifications")
Replace the batteries with ori-
ginal spare part (see "Batte-
ries replacement")
Clean and eliminate any oxida-
tion from the batteries con-
tact points (see "Robot
cleaning").
Recharge the batteries for at
least 12 hours.
Correctly programme the se-
condary area (see "Program-
ming mode")
Check the functionality of the
electricity supply, correct con-
nection of the transmitter-
power supply group and that
of the recharging station (see
"Installation of recharging sta-
tion and transmitter-power
supplier group")
- 52 -
Caution
User's manual