Programming Mode; Remote Control Description - AMBROGIO BASIC User Manual

REMOTE CONTROL DESCRIPTION

– Push buttons (A-B): they are
used to make the robot bend
towards right or left.
The robot keeps on bending to-
wards a direction or the other un-
til the relating push button (right
or left) is kept pressed. When the
push button is released, the robot
proceeds along a straight path.
– "Start" button (C): used to ac-
tivate the robot at a distance
(handling, stop and restart of
the blade and transfer from
one area to another).
– "Charge" button (D): used to
carry out the operations listed.
Remove the equipment from the
recharging base and start the work cy-
cle only if it has been programmed.
The equipment must perform a spiral
motion (only if switched on and in mo-
tion).
Recharge the equipment
switched on and in pause mode).
Remove the equipment from the perime-
ter wire if the equipment follows the wire
and does not perform its work correctly.

PROGRAMMING MODE

Proceed as indicated.
1-Press key.
2-Insert the pass-
word (if request-
ed) (see "Enter
password").
3-If the robot is switched on inside the
recharging base, after a few sec-
onds, the message "LOADING" ap-
pears on the display.
pushbutton
"Start/Pause" (C)
Left arrow (A)
Important
The remote control is provided already
programmed with a univocal code as-
sociated to the referring robot.
(only if
If the remote control does not work,
because it does not recognize the code
associated to the referring robot, it is
necessary to carry out its program-
ming (see "Programming mode").
4-Press key.
On the display the dis-
play
function appears.
5-Press key.
- 31 -
Right arrow (B)
pushbutton "Charge"
the "PAUSE"
GB
IDM - 41501703600.tif
User's manual