AMBROGIO BASIC User Manual page 14

PREPARATION AND DELIMITATION OF WORK AREAS
(MAIN AND SECONDARY)
Arrangement of lawn to trim
1-Check that the lawn to trim is
even, and without pits, stones
or other obstacles. If so, per-
form the necessary clearance
operations.
If some obstacles cannot be
removed, it is necessary to
properly mark the areas in-
volved.
GB
2-Check that all the areas of the
lawn do not exceed the admis-
sible gradients (see "Specifica-
tions"). During the work phase
on slopes, when the robot de-
tects the wire the wheels may
slide and make it exit from the
perimeter area. To avoid this
problem, it is possible to install the
"Slopes kit" and the "Clawed" wheels.
Important
The areas, showing higher gradients
than those
trimmed with the robot.
Marking of working area
3-Check the whole surface of the
lawn and assess whether it is
necessary to divide it in more
separated working areas.
Before starting installation op-
erations of the perimeter wire,
to make them easy to perform,
it is recommended to properly
signal the whole path evenly
with straight lines and to trace
any curved line.
The figure represents an ex-
ample of lawn with the trace
for the underground laying of
the perimeter wire.
admitted cannot
If the proper kit is installed and the condi-
tions of the ground are suitable (solid,
without excessive folds, etc.), the robot
can work (within certain limits) beyond
the maximum admissible gradients.
see figure
be
track for perimeter wire
- 14 -
IDM - 41501600700.tif
laying
IDM - 41501700800.tif
User's manual