Menu Settings - Programming Mode - AMBROGIO LINE 250 User Manual

Robot Programming
EN
10:30
Setting of timer
P1
10:30
⏎
Work schedule
MON TUE
00
06
12
18
24
10:30
⏎ ⏎
Daily schedule
T1 T2 T3
WORKING TIME
: -
09 15
WORK AREAS
A1 A2 A3 A4
10:30
⏎ ⏎
secondary area 2
(20%, 30MT, Anti-clokwise)
anti-clockwise direction
User's manual
MENU SETTINGS – PROGRAMMING MODE
P2 P3
WED THU FRI SAT SUN
1 2 3
T4
4 5 6
:
10 15
7 8 9
EDGE CUTTING
0
primary area
secondary area 1
(30%, 60MT, clokwise)
clockwise direction
Important
-
To get the best out of the robot, it is recommended to
program the robot to work every day.
-
If several working areas need to be set, it is recommended
to program at least two working schedules in order to
increase the cutting frequency in the areas.
Three different working profiles can be set for using at specific times. This is
particularly useful when you want to use the garden at a different time than
usual.
The last profile set remains highlighted in a different colour and will be active
during the automatic operation of the robot.
Press the button a few times to go to the main menu.
Up to 4 working schedules can be set for each day of the week.
Press the area of the display corresponding to the day you want to configure,
and then select the times.
PLEASE NOTE: If you want to copy the settings of one day to another, first
select the , symbol, then the day that you want to copy the settings from,
and then the days one by one that you want to copy the settings to. When you
have finished copying the settings, press
For each working schedule (T1,T2,T3,T4) set the start time, end time and the
mowing areas.
Times T1,T2,T3,and T4 must not overlap, the robot will delete
any conflicting times.
"Edge cutting". This function enables the robot to start working by cutting along
the edge of the lawn. This function should be activated at least twice a week.
For example, if you set:
T1: 09:00 - 11:00, A1, A2, A3, A4
T2: 15:00 - 17:00, A1, A2
The robot operating between the hours 15:00-17:00 will perform the mowing
cycle only in the A1 or A2 working area.
The robot can enter areas A3 and A4 when it has to reach a
working area, return to the charging station or work randomly.
The setting of the time is essential for the robot's proper functioning.
Many parameters influence the setting of the working schedules,
such as the number of areas, capacity of the batteries, complexity
of the lawn, type of grass, etc. Generally, the working hours must be
increased slightly when mowing gardens with more than one area,
and gardens with lots of obstacles and complicated areas. Below is
a table with the indicative times for configuring the robot on first use.
24
.