Table of Contents
Advertisement
CLEANING THE LOWER PADDLE
The Lower Paddle needs to be cleaned once a month in
order to operate efficiently. The ash dumping process
causes the holes in the lower paddle to eventually clog
with ash.
1.
Make sure the Room Heater is off and cool.
2.
On the control panel, push the "ON" and then
the "OFF" button immediately to clear the burn
pot and to place the lower paddle in the correct
position for cleaning.
3.
Unplug the Room Heater.
4.
Open the glass door or ash drawer to gain access to
the burn pot.
5.
Looking into the burn pot, insert a 1/8" drill bit,
toothpick, or similar diameter tool into the holes,
clearing each blocked hole.
CLEANING THE AIR FILTER FOR THE IGNITION
AIR COMPRESSOR
The air filter for the air compressor will only need to
be cleaned if the Room Heater is installed in a dusty
environment. Inspect filter annually. If it appears dirty,
remove and clean with a mild detergent and water. Once
dry, replace.
REPLACING THE ROOM HEATER FILTER
The air filter for the Room Heater is located on the back of
the Room Heater. The filter should be checked monthly
and replaced every 2 to 3 months depending on usage.
A clogged filter will reduce the efficiency of the Room
Heater. The filter can be replaced with most 16" x 16"
x 1" filters, or if not available, 20" x 16" x 1" filters. Do
not run the Room Heater with out the filter in place as
it's primary function is to keep dust and dirt out of the
mechanical components in the Room Heater.
28
Figure 35
Air Compressor
Figure 36
Burn Pot
Holes
Air Filter
2020866 REV A
Hide quick links:
Advertisement
Table of Contents
