Table of Contents
Advertisement
FUEL HOPPER
The Fuel Hopper should be cleaned out on a regular basis
(monthly) to remove fines and ensure proper fuel delivery.
1.
Remove the hopper cover and set aside.
2.
Empty the hopper of as much fuel as possible by either
running the Room Heater, shop vac, or by hand.
3.
Vacuum the base of the feeder wheel to remove small
particles and other debris.
4.
Remove the feed wheel access plate and vacuum around
the feed wheel.
CLEANING THE GLASS
Depending on the fuel used and the amount of use, the glass
window will need to be cleaned. The glass can be cleaned using
any available glass cleaner. Do not use abrasive cleaners to clean
the glass. For tough cleaning use cleaners designed for ceramic
stove tops.
CAUTION:
Before cleaning the glass, allow the Room
Heater to cool (minimum 2 hrs). Do not spray
window cleaner on the glass if hot.
If the glass needs to be cleaned more than every 4 to 5 bags
of fuel (two full hoppers), contact your dealer to verify Room
Heater operation.
NOTE:
Tighten door latch after the first month of
operation to maintain door seal.
CLEANING THE FEEDER TUBE
The Fuel Feeder Tube should be cleaned out on a regular basis
(monthly) to ensure proper fuel delivery.
1.
Allow Room Heater to cool, minimum 2 hrs.
2.
Open the Glass Door.
3.
Using a screw driver or small brush, scrape the inside of
the feeder tube.
If the tube needs to be cleaned more than every 4 to 5 bags of fuel
(two full hoppers), clean the fuel hopper (above).
2020866 REV A
Feed wheel access plate
Clean this area
Figure 33
Feeder tube
Figure 34
27
Hide quick links:
Advertisement
Table of Contents
