Specifying The Type Of Operation (Source Mode); Connecting To External Pedals - Boss RC-300 Loop Station Owner's Manual

Phrase Memory Settings
Parameter
Assign1 Src Mode
MOMENT

Connecting to External Pedals

Connect your EXP pedals ( EV-5
, etc .
The function of the external pedal (EXP pedal or foot switch) can be assigned independently for each phrase memory . For details, refer to "Assigning
the Function of Pedals and External Controllers (Assign)" (p . 23) .
When Connecting EV-5s
EXP 3 EXP 2
* Use only the specifi ed expression pedal (Roland
EV-5, etc . ; sold separately) . By connecting
any other expression pedals, you risk causing
malfunction and/or damage to the unit .
Default assignments of functions controlled
The default assignments are as follows . If you simply connect pedals without making any settings, you can use them to control the following
parameters and functions .
Assign Switch Assign Source
Assign1 ON EXP1 PEDAL
Assign2 ON EXP2 PEDAL
Assign3 ON CTL1 PEDAL
Assign4 ON CTL2 PEDAL
Assign5 ON CTL3 PEDAL
Assign6 ON CTL4 PEDAL
Assign7 ON SYNC START/STOP
Assign8 OFF
24 24
Value Explanation
Specifying the Type of Operation ( Source Mode)
If a momentary-type foot switch (such as the separately sold FS-5U) is connected as the source, you can specify how
foot switch operations will aff ect the value .
* If the [LOOP FX] pedal is set to MOMENT, it will no longer be possible to enter Pedal Function mode (p . 10) by
holding down the [LOOP FX] pedal for two seconds or longer .
The setting will normally be off (minimum value); it will be on (maximum value) only while
MOMENT
you continue holding down the foot switch .
The setting will alternate between off (minimum value) and on (maximum value) each time
TOGGLE
you press the foot switch .
; available separately) or foot switches ( FS-5U, FS-6; available separately) as shown in the illustration .
When Connecting FS-5Us
Red White Red
CTL 4 CTL 3 CTL 2
POLARITY switch
* If you use a mono cable to connect a single FS-5U, the CTL 1, 2 jack will be CTL 1, and the CTL 3, 4 jack will be CTL 3 .
Assign Target
EFFECT CONTROL
Level
MEMORY INC
MEMORY DEC
FX TYPE INC
FX TYPE DEC
ALL PLAY/STOP
When Connecting FS-6s
Cable:
Stereo 1/4" phone
type g
1/4" phone type x 2
White
CTL 1 CTL 4 CTL 4 CTL 3 CTL 3
MODE/POLARITY switch
Explanation
The eff ect that's most suitable for the selected LOOP FX type will be
applied .
The pedal will control the volume of the phrase memory .
The pedals will switch phrase memories .
The pedals will switch the LOOP FX type .
All tracks can be simultaneously played/stopped upon reception of
ALL START/STOP messages from the master RC-300 unit (p . 39) .
Cable:
Stereo 1/4" phone
type g
Stereo 1/4" phone type
CTL 2 CTL 2 CTL 1 CTL 1