Advertisement
OPERATION
For FUZZ 1 or FUZZ 2:
1
Once
you have all the
connections made, set the
knobs on the panel so they
conform to the illustration
below,
* Have the Mode knob set to
either FUZZ 1 or FUZZ 2.
*
Before
connecting
or
disconnecting any instrument,
make sure that the volume of
the amplifier is turned down,
2 Step on pedal switch (7) to
turn ON the effect. (The
Check indicator will light.)
4 Adjust both the BASS and
TREBLE Tone knobs (5 & 4)
until you have the tone you
desire.
ka
j
Reve
TONE
OAN tn
ona © % woe
cur
Use the Gain knob (10) to
adjust
the
amount
of
distortion. The distortion
depth is increased as you
move the knob to the right.
* Oscillation could be produced
if the depth is increased too
much,
Adjust the Level Knob (3) so
there
is no
noticeable
difference between the times
when the effect is applied
and when
the sound
is
For GAIN BOOST:
1
2 Step on pedal switch (7) to turn ON the effect.
When set to this mode, the Level knob (3) will
not provide its normal function.
Once you have all the connections made, set
the knobs on the panel so they match the
illustration below.
* Have the Mode knob set to GAIN BOOST.
(The Check indicator will light.)
you move the knob to the right.
* Oscillation could be produced if the depth is increased
too much.
CHECK
O
3 Use the Gain knob (10) to adjust the amount by
which to boost the gain. The gain is increased as
4
Adjust both the BASS and TREBLE Tone knobs
{5 & 4) until you have the tone you d esire.
Advertisement
