Adjusting The Auto Recording Sensitivity (Trigger Level); Overdubbing G Playback (Rec Pedal Action); Using The Same Output Jacks For All Phrase Memories; (Input/Track 1, 2, 3/Rhythm Output) - Boss RC-300 Loop Station Owner's Manual

Parameter
Sys: Auto Rec
Trigger 50
Sys: REC Pdl Act
REC→OVERDUB
Sys: Input Out
MEMORY
Sys: Track1 Out
MEMORY
Sys:Track2 Out
MEMORY
Sys:Track3 Out
MEMORY
Sys: Rhythm Out
MEMORY
Sys:SUB OUT Lev
100
Sys: Auto Off
ON
System Settings (Settings for the Entire RC-300)
Value Explanation
Adjusting the Auto Recording Sensitivity ( Trigger Level)
This sets the input level at which recording is started (the trigger level) when Auto Recording (p . 22) is used .
0–100 Input levels at or above the value set here will cause recording to start .
Changing the Switching Order of Recording g
Overdubbing g Playback ( REC Pedal Action)
When you press the [REC/DUB/PLAY] pedal, the RC-300 will switch its operation in the order of recording g
overdubbing g playback (p . 10) . However, you can change this so that the order is recording g playback g
overdubbing .
REC g OVERDUB Operation will switch in the order of Recording g Overdubbing g Playback .
Operation will switch in the order of Recording g Playback g Overdubbing .
REC g PLAY

Using the Same Output Jacks for All Phrase Memories

(Input/ Track 1, 2, 3/Rhythm Output)
Normally, the settings determining which jacks are used in outputting input sounds, tracks, and rhythm sounds are
stored in each phrase memory, but you can select, as a setting aff ecting the RC-300 overall, to have all of these use
the same output at all times .
MEMORY The output destination specifi ed by the phrase memory will be used .
Regardless of the setting of the phrase memory, the sound will be output from the MAIN
MAIN
OUTPUT jacks and the PHONES jack .
Regardless of the setting of the phrase memory, the sound will be output from the SUB
SUB OUTPUT jacks . The sound will not be output from the MAIN OUTPUT jacks or the PHONES
jack .
Regardless of the setting of the phrase memory, the sound will be output from the MAIN
MAIN+SUB
OUTPUT jacks, the SUB OUTPUT jacks, and the PHONES jack .
Regardless of the setting of phrase memory, the input sound will not be output .
MUTE
(Input Out only)
* Tracks will be recorded .
Adjusting the Output Level of the SUB OUTPUT Jacks
( SUB OUTPUT Level)
You can adjust the output level of the SUB OUTPUT jacks .
0–200 Output level of the SUB OUTPUT jacks .
Auto Off Settings
The RC-300 can turn off its power automatically . The power will turn off automatically when 10 hours have passed
since you last played or operated the unit . The display will show a message approximately 15 minutes before the
power turns off .
With the factory settings, this function is turned "ON" (power-off in 10 hours) . If you want to have the power remain
on all the time, turn it "OFF . "
NOTE
When the power is turned off , any settings you were editing will be lost . You must save settings that you want
to keep .
OFF The power will not turn off automatically .
The power will automatically turn off when 10 hours have passed since you last played or
ON
operated the RC-300 .
33