Table of Contents
Related Manuals for Boss RC-50
Summary of Contents for Boss RC-50
- Page 1 Workshop RC-50 Loop Station Audio Inputs and Outputs © 2006 BOSS Corporation U.S. All rights reserved. No part of this publication may be reproduced in any form without the written permission of BOSS Corporation U.S. RC50WS04...
-
Page 2: About This Booklet
Each RC-50 Workshop booklet focuses on a specific topic to help you • When a phrase is empty, capturing audio into it is called “recording. ” get the most out of your RC-50 and spark some ideas for its creative use. • While recording a phrase, pressing the REC/PLAY/OVERDUB pedal RC-50 Workshop booklets are intended as companions to the RC-50 Owner’s... -
Page 3: Making Connections
If your device has a stereo output but uses a different type of jack (or MIC Input jacks), you can still connect it to the RC-50’s AUX jack by acquiring the appropriate cable or cable adaptor. The MIC input jack accepts an XLR connector,... - Page 4 RC-50’s outputs, as you’re already hearing it from the GT-8’s MAIN each patch. outputs. By muting it on the RC-50, you can avoid this duplication. Press EXIT when you’re done.
-
Page 5: Input Mode Settings
RC-50 Workshop booklet Patches or Page 54 in the RC-50 Owner’s Manual. Input Mode Settings If you’re using the RC-50 with a guitar amp, you’ll probably find that an The Input mode settings affect how audio signals are electric guitar connected to the INST input(s) sounds great, while signals recorded from the RC-50’s audio inputs. - Page 6 MIC and AUX input jacks. It alters the tonality of these signals so they sound better when played through a frequency-limited amplification The RC-50’s rear panel has two pairs of stereo outputs and a PHONES jack. system. To disable Flat Amp Simulate, set it to OFF.
-
Page 7: System Output Settings
If you want to save your patch output settings, you’ll need to save Press EXIT when you’re done. the patch to one of the 99 onboard patch locations. To learn how, see the RC-50 Workshop booklet Patches or Page 54 in the RC-50 Owner’s Manual. -
Page 8: Master Level
Use the PARAMETER buttons to display the selected phrase’s Level screen. In addition to using the MASTER LEVEL knob, you can set the RC-50’s overall Turn the PATCH/VALUE dial to set the phrase’s level, from 0 to 200. level on a per-patch basis. The difference between the MASTER LEVEL and Use the PARAMETER buttons to display the selected phrase’s Pan... -
Page 9: Connections And Setup
Patches, or Page 52 in the RC-50 Owner’s Manual. (When an Switch Switch RC-50 patch is in an initialized state—that is, a blank patch that’s set to factory settings—all of its phrases are set for looped playback by Mono input Mono input default.) - Page 10 Repeat the above steps to record and overdub to additional phrases. and www.RolandUS.com. Creative Uses for the Outputs For the latest RC-50 updates and support tools, visit the BOSS U.S. With the ability to route sounds to multiple outputs and pan www.BOSSUS.com Web site at .
Need help?
Do you have a question about the RC-50 and is the answer not in the manual?
Questions and answers