Manually Jamming Tc With A Cable; Continuously Jamming Tc Using The Ifb100; Automatically Starting And Stopping The Recording Using Timecode From The Ifb100 - Zaxcom TRX900 User Manual

Chapter 3_______________________________________Zaxcom Digital Wireless System User's Manual
NOTE: The transmitter does not continue to keep timecode when it is powered down. Every time the unit's
power is cycled, it will be necessary to jam its internal-clock.

Manually Jamming TC with a Cable

Timecode can be jammed into the transmitter by connecting the timecode source to the microphone input or
using the stereo adapter. When timecode is connected, it takes the transmitter approximately three (3) seconds
to recognize the TC input. The screen display
recognized. When the word
operation can be resumed.
When using the mic input connector with a mic-level source, the audio level of the timecode needs to be between
-30 and -10 dBFS on the transmitter's meter. Any level above -10 may cause clipping, which will prevent proper
reading of timecode.
When using the mic input connector with a line-level source, a line-level to mic-level cable should be used to
attenuate the timecode signal out of a generator to the correct audio level.
When using the line-level input connector (STA100 or TCA100) with a line-level source, a non-attenuating cable
should be used.
In the transmitter {TRXxxx} or recorder {ZFR1xx}, in the Extended Menu:
a. Set the
b. Set the
NOTE: The TRX800 cannot be jammed. It will always start at 00:00:00.

Continuously Jamming TC using the IFB100

1. In the transmitter {TRX900 ( /AA) or TRX992} or recorder {ZFR1xx}, in the Extended Menu:
a. Set the
b. Set the
2. In the IFB100:
a. Connect the TC source to the TC-IN connector.
b. Set the
c. Set the

Automatically Starting and Stopping the Recording using Timecode from the IFB100

1. In the transmitter {TRX900 ( /AA) or TRX992} or recorder {ZFR1xx}, in the Extended Menu:
a. Set the
b. Set the
2. In the IFB100:
a. Connect the TC source to the TC-IN connector.
b. Set the
c. Set the
JAMMED
Timecode Jam Mode page
Timecode Source page to
Timecode Jam Mode page
Timecode Source page to
Timecode Jam Mode page
Timecode Source page to
Timecode Jam Mode page
Timecode Source page to
Timecode Jam Mode page
Timecode Source page to
followed shortly by
TIME CODE
disappears, the timecode input source can be disconnected and normal
to .
Manual
SIDE CONNECTOR
to .
AUTO-JAM
.
IFB (RF)
to or
AUTO-LOAD AUTO-JAM
SIDE CONNECTOR
to .
AUTO-LOAD
.
IFB (RF)
to .
AUTO-LOAD
SIDE CONNECTOR
44
JAMMED
or . (as appropriate)
AUDIO INPUT
.
.
.
when it is