Record Setup - Datavideo DN-600 Instruction Manual

Record Setup

When selected from the Main Menu Level, this set of options enable various record related
parameters and modes to be setup. The lower three lines will look as below:
There are 8 options and they are:
Pressing the Next key will bring up the next option down on the list and will return to the top option
from the bottom. Table 2 details the actions for each option. Pressing the Menu key will exit to the
Main menu level.
Menu Option
SET RECORD FILE
TYPE
SYNCtoTAPE
CONTROL
SET RECORD DATE
RECORD PRE-
TRIGGER
SET DEFAULT DV
AUDIO
SET ASPECT RATIO
TIMELAPSE RECORD
PWR ON AUTO
RECORD
SET RECORD FILE TYPE
SYNCtoTAPE CONTROL
SET RECORD DATE
RECORD PRE-TRIGGER
SET DEFAULT DV AUDIO
SET ASPECT RATIO
TIMELAPSE RECORD
PWR ON AUTO RECORD
Where the choice of file type is made for all recordings.
Note that file types cannot be mixed within a bin.
Choices are .mov, 2 types of .avi, .mxf and for HDV, .m2t only.
Note that the current selection will be marked with an asterisk [*].
Where the recorder will look to the time code changing to indicate the
need to record. If the time code pauses then the recording is paused.
With this setting turned off, the record process will continue regardless of
the time code behaviour.
Note that the current selection will be marked with an asterisk [*].
This option modifies the date attribute of the created file when the source
is analogue CVBS. It is also used when the source is digital if the date in
the digital source is invalid.
When enabled, the last 8 seconds of video prior to the record trigger are
captured ahead of the video following the trigger.
Note that the pre trigger is not remembered across power cycles.
When the source is analogue CVBS, this option sets the audio sampling
frequency. When the source is digital, this option helps the recorder
make a correct guess for the incoming audio sampling frequency.
Note that the current selection will be marked with an asterisk [*].
When the source is analogue CVBS, this option sets the 16:9 or 4:3
aspect ratio flag in the stream to be recorded. For DV or HDV recordings
ensure the source equipment is set correctly for the desired aspect.
Allows the DV25 recording of video at slower than real time through a
choice of one of 6 options.
Note that the current selection will be marked with an asterisk [*].
When enabled, the recorder will go directly into a record mode in the last
BIN selected once power is applied.
14
Action taken
Table 2 Record Setup Level