Pulse Trigger Playback Process; Level Trigger Playback Process - Datavideo DN-600 Instruction Manual

PULSE trigger Playback process

Using the Clip Status Display and soft keys select a pre-recorded video BIN. Make sure the output
device/monitor is connected and working with the recorder. Press in the Play button on the recorder's
front panel. This should start the playback. The button on the connected GPI cabling is then pressed
forcing the unit into play pause mode. The unit is then ready to playback from this point on the next
press of the contact closure button. Press the stop button on the front panel of the recorder to end
playback of the video.

LEVEL trigger Playback process

Using the Clip Status Display and navigation buttons select a pre-recorded video BIN. Make sure the
output device/monitor is connected and working with the recorder. Press in the Play button on the
recorder's front panel. This should start the playback. The button on the connected GPI cabling is
then pressed forcing the unit into play pause mode for the length of the press. However, when the
button is released the playback starts again. Press the stop button on the front panel of the recorder
to end playback of the video.
The contact closure button may be working in the opposite way to the type of action you want to
perform. A mechanical change to the GPI contact closure trigger should fix this. ( Example: When
pressed down the circuit is broken and recording starts. When released the contact is made causing
the pause action. )
28