230V Operation - Jet JWL-1642EVS Operating Instructions And Parts Manual

Wood lathe
Hide thumbs Also See for JWL-1642EVS:
Table of Contents

Advertisement

230-Volt Operation (Model JWL-1642EVS-2 only)
1. A plug with a UL/CSA listing suitable for 230V operation (Figure D) must be connected to the
power cord. Contact your local authorized WMH Tool Group service center or qualified electrician
for proper procedures to install the plug. The lathe must comply with all local and national codes
after the 230V plug is installed.
2. The lathe with a 230V plug should only be connected to an outlet having the same configuration
(Figure D). There is no adapter available nor should one be used with the 230V plug.
In all cases (115 or 230 volts), make certain the receptacle in question is properly
grounded. If you are not sure, have a registered electrician check the receptacle.
Note: The JWL-1642EVS-2 lathe requires a 230-volt single-phase input. It is equipped with a power
inverter, located between the power cord and the drive motor. The inverter takes the 230V 1-phase input
from the power cord and converts it to the 230V 3-phase output required by the drive motor.
6

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JWL-1642EVS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Jwl-1642evs-2

Table of Contents