Pillow Care - Sundance Spas Camden Owner's Manual

5. After spa has drained, close drain valve by pushing inward on garden
hose end at drain connection until you feel it bottom out. Remove
garden hose and install gray drain cap before refilling spa. Note:
the gray drain cap cannot be installed until the drain valve is closed.
Refer to "Spa Fill Up Procedure" (page 15) for recommended filling
instructions.

11.3 Pillow Care

Remove and clean the headrest pillows as needed
with soapy water using a cloth or soft-bristle brush. To
maintain water resistance and luster, apply a quality
vinyl conditioner once a month. Always remove the
pillows when adding chemical shock treatment to the
spa water. The pillows can be returned to the spa when the sanitizer
reading drops below 4.0 ppm. Note: Metro pillows vary in appearance,
not shown.
Pillow Removal/Cleaning Procedure
1 1
Place both hands on Place both hands on
pillow with thumbs as pillow with thumbs as
shown. shown.
Wash pillow(s) in a mild detergent soap and warm water solution. Never machine wash your pillows Wash pillow(s) in a mild detergent soap and warm water solution. Never machine wash your pillows
5 5
or attempt to clean them with a non-approved vinyl cleaning agent! or attempt to clean them with a non-approved vinyl cleaning agent!
To reinstall pillows: Simply align pillow over mounting stud receptacle, then gently push inward to snap in place. To reinstall pillows: Simply align pillow over mounting stud receptacle, then gently push inward to snap in place.
6 6
Page 32
2 2
Press inward with Press inward with
thumbs to curl pillow thumbs to curl pillow
lip inward so you can lip inward so you can
grab it with fingertips. grab it with fingertips.
3 3
Flex pillow lip inward Flex pillow lip inward
2-3" to get a good 2-3" to get a good
grip on the ends. grip on the ends.
4 4
Gently pull outward on Gently pull outward on
pillow to release mounting pillow to release mounting
stud from receptacle on stud from receptacle on
spa shell. spa shell.