Sundance Spas Camden Owner's Manual page 36

Loosen filter nut to provide clearance, then
remove filter assembly.
Note: Remove and clean the Stage 1
D
filter cartridge once a month.
Top
Rinse debris from all filter pleats using a
garden hose and high-pressure nozzle. Start
at top and work downward to face. Repeat
process until all filter pleats are clean.
F
Trapped
Air
Bubbles
Submerge assembled filter in spa and tilt each
end upward to remove trapped air bubbles
from inside each filter cavity.
Periodically, the polyester mesh (pleated) filter will need a more thor-
ough cleaning to remove imbedded oils and minerals. For this, we
suggest cleaning as illustrated above (step D), followed by soaking the
filter overnight in a plastic container filled with a solution of water and a
specially formulated filter cleanser available from your Sundance dealer.
CAUTION! Never scrub the polyester mesh filter cartridge
with a brush as this will cause the polyester mesh to wear
out and come apart. Never let the spa pump run or have
a filter cycle come on without a filter cartridge in the skim-
mer compartment. Running the spa without a filter cartridge
may permit debris to enter the spa plumbing and void the
warranty!
Page 30
1. Rotate stage 2 retainer counterclockwise
to release, then separate filter assembly.
2. Replace (throw-away) stage 2 filter after 3
months use or as needed. DO NOT REUSE!
E
Reusable
Stage 1
Filter
1. Install new stage 2 filter onto clean stage 1 filter.
2. Insert retainer into stage 2 filter and rotate
G
1. Install filter assembly, then tighten filter nut so it
2. Turn power to hot tub back on.
filter
Note: The Stage 2 filter cartridge cannot be
cleaned and must be (thrown out) replaced
every 3 months, or as needed.
2. 1.
New
Stage 2
filter
clockwise to assembly. DO NOT OVERTIGHTEN
RETAINER (FINGER TIGHT ONLY)!
just touches filter face. DO NOT OVERTIGHTEN!
(Reuseable)
Stage 1
filter
Filter
Nut