Toshiba TECRA A11 Series Maintenance Manual page 334

Installing the Cover assembly and Base assembly
To install the cover assembly and base assembly, follow the steps below and refer to Figure
4-23 to 4-25.
1. Place the cover assembly on the base assembly and secure them
screws.

M2.58B

M2.512B
2. Turn up the insulator (LCD CONN INSULATOR) and connect the LCD harness to
the connector CN5300 on the system board.
NOTE: Arrange the LCD harness under the guides.
Guide
3. Connect the FS board FFC and camera harness to the connector CN9550 and
CN9540 on the system board.
4. Turn over the computer and secure the cover assembly and base assembly with the
following screws.

M2.58B
5. Connect the RGB harness and serial port FFC to the connector CN9510 and
CN9520 on the system board.
4-44 [CONFIDENTIAL] TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784)
FLAT HEAD screw
FLAT HEAD screw
Guide
FLAT HEAD screw
with the following
5
3
Guide
LCD harness
11 ("8" in the Figure 4-23)