Set Copy - SpectraLink Link 150 Installation And Operation Manual

SpectraLink
Complete and Copy Programming
The rest of the programming steps depend on the way the wireless telephones are used at
your site.
At Your Site
All Wireless Telephones Are
Programmed Alike
All Wireless Telephones Are
Programmed Different
Groups of Wireless Telephones Are
Programmed Alike
Program General Settings
From the Configuration Programming Mode on the Norstar, set the following options for
the SpectraLink DNs.
• Full Handsfree: Y
• Auto Handsfree: N
• Handsfree Answer Back: N
• Page Zone: None
You may change or assign other General Settings or Set Abilities to match the wired
telephones at your site, but the settings listed above must be set as indicated.
Program Line Access
From the Configuration Programming Mode on the Norstar, program the Line Access
options for the SpectraLink DNs. This includes line assignment, Answer DNs, Ringing,
Line Pool access, Intercom buttons, and Prime Line assignment. Options should be
programmed for all "template" DNs or individual DNs, according to the pre-installation
plan.

5. Set Copy

After the SpectraLink "template" DNs have been programmed, use the
in Configuration Programming to copy the programming to all "like" SpectraLink DNs.
You can copy both System and User programming if you are using an M7310 set.
The installer can now test the wireless telephones.
12/28/98
Link 150 Installation and Operation
Follow These Steps
Program General Settings
Program Line Access
Use Set Copy to copy programming to all other wireless
telephones
Since all wireless telephones are different, no
programming is copied
Program General Settings on each set
Program Line Access on each set
Use Set Copy to copy memory buttons to all wireless
telephones
Program General Settings for a group
Program Line Access for a group
Use Set Copy to copy to all wireless telephones in a group
function
Set Copy
63