Standby; About Standby; Leaving Standby Mode; Entering Standby Mode - TANDBERG MXP User Manual

What's in this guide? Getting started

Standby

About standby

The system will automatically go to
standby mode when it is not in use. In
standby mode, the screen(s) will turn
black. It is, however, still possible to
receive incoming calls.
The standby mode of the system should
be enabled if the system is to be left
idle.
Standby is not activated by
switching off the power to the
monitor(s). Some TANDBERG
systems come with monitors that
cannot be switched off.
If the system is set to be using
the screen as PC display, the
standby mode will be disabled
when the system detects a video
signal from the PC. When the PC
video signal no longer is detected,
the standby mode will be re-
enabled.
D1403405 USER GUIDE VIDEO ENDPOINTS MXP ENGLISH—SEPTEMBER 2009
Getting started Making calls

Leaving standby mode

When the system is in standby, pick up
the remote control or press any key to
activate the system again.
Using the phone book

Entering standby mode

Outside a call, press OK to
produce the main menu, if
needed, and navigate to the
Standby icon.
Press the OK key.
To enter standby mode here and
now, navigate to the Standby
Now icon and press the OK key.
However, if you instead want to postpone (delay) the standby for 1 hour or 3
hours, you should select one of the other icons before pressing the OK key.
The below example shows 3 hours delay highlighted (selected).
Select this icon
to have standby
(delayed) by 1
14
In-call features Video conferencing
postponed
hour.
Select this icon to have
standby postponed
(delayed) by 3 hours.