Table of Contents
Advertisement
TIP
TIP
Use PC-CDU to configure data logging. See "MINTER
Configuration" on page 2-22 or refer to the PC-CDU
User's Manual.
3. When finished, press and hold the FN key until the REC
LED light goes out.
4. To turn off the receiver, press and hold the power key until
all lights go out, then release.
Surveying with the Receiver
Your receiver can be used to perform the following types of
surveying:
• Static
• Kinematic
• Real-time kinematic (RTK)
Static Survey
Static surveying is the classic survey method, well suited for all
kinds of baselines (short, medium, long). At least two receiver
antennas, plumbed over survey marks, simultaneously collect
raw data at each end of a baseline during a certain period of
time. These two receivers track four or more common satellites,
have a common data logging rate (5–30 seconds), and the same
elevation mask angles. The length of the observation sessions
can vary from a few minutes to several hours. The optimal
observation session length depends on the surveyor's
experience as well as the following factors:
• The length of the baseline measured
• The number of satellites in view
P/N 7010-0557
Surveying with the Receiver
www.topconpositioning.com
3-5
Advertisement
Table of Contents
