Connecting The Hd Radio; Tm Receiver To A Cable Radio Signal; Antenna Grounding; Notice For Cable Tv System Installer - Jensen HD Radio JiMS-525i Owner's Manual

Connecting FM / HD Radio
This Radio's FM Antenna Connector is a standard connector that will accept
either the FM Antenna wire (included) or the cable FM feed from most cable
systems that provide FM programming. To connect the included FM Antenna
wire, slide the black plastic end of the antenna wire onto the center post of
the antenna connector on the back of the unit. To connect your Radio to the
FM signal available from some cable TV providers, contact your cable TV
provider for assistance and also to find out if HD Radio
are available through the cable line. As of the writing of this manual, HD
TM
Radio signals are not being rebroadcast via cable providers.
Be sure that the installation includes a splitter that will filter the signal to prevent any
re-emission of the TV spectrum through the Radio, so that only the FM band, not the
cable TV signal, is transmitted to the Radio.

Antenna Grounding

Example of antenna grounding, per the National Electrical
Code, ANSI/NFPA 70.

Notice for Cable TV System Installer

Please make note of Article 820-40 of the NEC
(of USA) that provides guidelines for proper
grounding. In particular, this standard specifies
that the cable ground shall be connected to the
grounding system of the building, as close to the
point of cable entry as is practical.

Connecting the AM Loop Antenna

If AM reception is weak for improvement connect the provided Loop
Antenna as describe below:
1. Push to open the 2 receptacles of the AM antenna terminals and
insert 2 open-end wires of the AM loop antenna into them.
2. Release the 2 AM antenna terminal handles to hold the AM loop
antenna wires in place.
3. Orient the AM loop antenna for the best reception.

AUX LINE-IN Connection

Connect one end of the Audio line cable (Included) to the AUX Input jack at the back of the Radio and
the other end of the Audio line cable to your external audio player, such as a CD, MP3 etc.
GETTING STARTED (Continued)
TM
Receiver Antenna / to a Cable Radio Signal
TM
broadcast signals
Ground Clamp
Electric Service
Equipment
Nec-National
Electrical Code
Power Service Grounding Electrode System
(Nec Art 250, Part H )
- 7 -
FM / HD RADIO AM RADIO
ANTENNA ANTENNA
CONNECTOR CONNECTOR
FM / HD RADIO
ANTENNA WIRE
Antenna Lead In Wire
Antenna
Discharge Unit
(Nec Section 810-20)
Grounding Conductors
(Nec Section 810-21)
Ground Clamps
AM loop
antenna
AM outdoor
antenna