Assembly; Unpack The Pressure Washer; Attach Handle To Unit - Briggs & Stratton FACTORY RECONDITIONED PRESSURE WASHER Operating And Maintenance Manual

Assembly

IMPORTANT: Read entire operator's manual before you
attempt to assemble or operate your pressure washer.
IMPORTANT: Contact your local service center or look on the
engine manufacturer's website to obtain an engine operator's
manual. You will need the engine manual to find engine
operation, maintenance and emissions warranty policy.
NOTE: Your pressure washer may not include all accessories
shown herein.

Unpack the Pressure Washer

1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner from
top to bottom.
3. Remove pressure washer from carton.

Attach Handle to Unit

Your pressure washer will be equipped with one of the
following handles. Please see the handle attachment section
that applies to your pressure washer.
To attach handle with accessory tray or cleaning tank:
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (C) in handle align with
holes (C) on handle supports (see Figure 1).
C
Figure 1 — Attach Handle to Base
NOTE: It may be necessary to move handle supports from
side to side in order to align handle so it will slide over
handle supports.
6
A
B
2. Insert carriage bolts (A) through holes from back of
unit and attach a plastic knob (B) from front of unit.
Tighten by hand (see Figure 2).
A
Figure 2 — Secure Handle
3. Place accessory tray or cleaning tank over holes on
handle (viewing from front of unit). Push the tree clips
into the holes until they sit flat against the accessory
tray or cleaning tank (see Figure 3).
Figure 3 — Attach Accessory Tray or Cleaning Tank to
Handle
B
OR
BRIGGSandSTRATTON.COM