How To Use The Turbo Nozzle - Briggs & Stratton FACTORY RECONDITIONED PRESSURE WASHER Operating And Maintenance Manual

If Unit is Equipped with Quick-Connect Spray Tips
The quick–connect on the nozzle extension allows you to switch between several different spray tips. the spray tips vary the
spray pattern as shown below (see Figure 26).
Low Pressure
Use to apply
Detergent
Black
Figure 26— Quick Connect Spray Tips
To Change Spray Tips:
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange spray tips without locking the trigger lock on
the spray gun.
• DO NOT twist spray tips while spraying.
1. Engage trigger lock on spray gun.
2. Pull back collar on quick–connect and pull current
spray tip off.
3. Select desired spray tip:
• For gentle rinse, select 40° or 25° spray tip.
• To scour surface, select 15° or red 0° spray tip.
• To apply detergent, select black spray tip.
NOTE: Your unit may NOT be equipped with all five spray
tips.
16
40° 25°
If Unit is Equipped with Turbo Nozzle
• Always make sure the surface you will clean will not be damaged
by the high pressure spray by testing in a hidden area.

How to Use the Turbo Nozzle

The turbo nozzle spins a 0° nozzle stream in a circular
pattern, providing an intense wide-spray pattern for scouring
large surface areas fast and efficient.
A turbo nozzle can easily cut through heavy oil and grease
stains on concrete, brick and plastic and strip paint from
various surfaces. DO NOT use the turbo nozzle on delicate
materials, especially wood. Always start the turbo nozzle at a
distance, gradually getting closer to the surface until you get
the cleaning force you want. Always keep the turbo nozzle in
a constant motion. NEVER dwell on a single spot. Pass over
stubborn stains repeatedly until they are gone using even
strokes.
To install the turbo nozzle with quick connect fitting:
1. Engage trigger lock on spray gun trigger.
2. Pull back collar on quick–connect and pull current
spray tip off. Store spray tips in holder provided on the
nozzle extension or the accessory tray.
15°
WARNING
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
The turbo nozzle produces an extremely high
pressure spray which is capable of removing
paint and cutting holes through surfaces if held
too close.
BRIGGSandSTRATTON.COM
High Pressure
Red
0°