Assembly - Briggs & Stratton TECHNOLOGY POWERflow+ Operator's Manual

Assembly

Read entire operator's manual before you
attempt to assemble or operate your new
electric pressure washer.
Your electric pressure washer requires some assembly
but is quickly ready for use. If you have any problems with
the assembly of your electric pressure washer, please call
the electric pressure washer helpline at (800) 743-4115. If
calling for assistance, please have the model, revision, and
serial number from the identification label available.
Tools Needed
• Philips screwdriver #2
Unpack Electric Pressure Washer
1. Remove everything from carton.
2. Ensure you have all included items prior to assembly.
Items Included in the Carton
• Main unit
• Handle with accessory tray
• Spray gun
• High pressure hose
• Nozzle extension
• 7-in-1 nozzle
• Handle support tubes (2)
• Parts bag (which includes the following):
• Red high pressure nozzle
• Water inlet coupling
• Screws (2)
• Handle bolts (2)
• Plastic knobs (2)
• O-ring kit
• Nozzle cleaning tool
• Operator's manual
• Owner's registration card
Check all contents. If any parts are missing or damaged, call
the electric pressure washer helpline at (800) 743-4115.
Become familiar with each component before assembling
the electric pressure washer. Identify contents with the
illustration shown in Features and Controls.
Prior to Operation
• Please fill out and send in the registration card.
• Read and perform the following instructions while
paying close attention to all warnings and notices.
NOTICE For best performance, connect ONLY to water
source capable of supplying greater than 5 GPM (18.9 l)
and 25-75 psi (1.72-5.17 bar) at the electric pressure
washer end of garden hose. Inspect all equipment, hoses
and accessories thoroughly before each use, DO NOT
use if damaged.
• ONLY use branded accessories intended for use with this
product.
• For optimum performance, DO NOT use a garden hose
that exceeds 50 feet in length.
• Replace only with original equipment parts. To order, call
(800) 743-4115 or visit BRIGGSandSTRATTON.COM.
6
Attach Handle Support Tubes and Handle
1. Slide handle support tubes (A) into slots on back of
main unit. Align and attach handle support tubes with
a screw (B) on each side. Maintain alignment while
tightening with a #2 philips screwdriver.
A
B
2. Place handle (C) onto handle support tubes
connected to main unit. Make sure holes in handle
align with holes on handle support tubes.
3. Insert handle bolts (D) through holes from inside of
unit and attach a plastic knob (E) from outside of unit.
Tighten by hand.
D
Lubricate O-Rings
Lubrication of o-rings is extremely important for installation
and operation. The use of a lubricant (petroleum or
synthetic grease) during assembly helps seat o-rings
properly and provides an improved seal. It also helps
protect the o-ring from damage by abrasion, pinching or
cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump
(A), high pressure hose (B), nozzle extension (C) and
spray gun (D).
D
C
C
A
B
BRIGGSandSTRATTON.COM
A
B
E