Related Manuals for Briggs & Stratton R020802
Summary of Contents for Briggs & Stratton R020802
- Page 1 Reconditioned Pressure Washer Operator’s Manual R020802 Copyright © 2022. Briggs & Stratton Milwaukee, WI, USA. All rights reserved. (800) 743-4115 Manual No. 80111265 Rev A...
-
Page 2: Table Of Contents
Table of Contents Automatic Shut-Off The electric pressure washer is equipped with a sensor Operator Safety......2 that will detect that water flow has stopped when releasing Assembly. - Page 3 WARNING Risk of electrocution. Use of an WARNING Risk of eye or bodily injury. Spray could extension cord could cause electric shock or splash back, propel objects or cause burn resulting in death or serious injury. internal harm resulting in serious injury. •...
- Page 4 WARNING This product contains lead and lead WARNING Risk of fire. Spraying flammable liquids compounds, known to the state of California to cause could result in death or serious injury. birth defects or other reproductive harm. Wash your hands after handling this product. Cancer and •...
-
Page 5: Assembly
Assembly Lubricate O-rings Lubricate all connections shown to extend the life of the Read entire operator’s manual before you o-rings. attempt to assemble or operate your new 1. Inspect and clean connecting surfaces prior to electric pressure washer. lubrication and assembly. Replace o-rings that are Your electric pressure washer requires some assembly damaged or missing. - Page 6 Connect Spray Wand and 7-in-1 Nozzle 2. Attach red end of high pressure hose (A) to high pressure outlet (B) on pump. Tighten by hand. 1. Turn ON the water, press red button (F) on the gun and squeeze the trigger to purge the pump system of air and impurities.
-
Page 7: Features And Controls
Features and Controls Read the Operator’s Manual and safety rules before operating your electric pressure washer. Compare the illustrations with your electric pressure washer to familiarize yourself with the locations of various controls and adjustments. Save this original manual for future reference. A - Spray Gun —... -
Page 8: Operation
Operation 7. Plug electrical power cord into a dedicated electrical circuit rated for 120 Volts AC at 15 Amps that is How to Start Your Electric Pressure Washer properly installed in accordance with all local codes and ordinances. Circuit is not to supply any other Follow the instructions below in the order presented. - Page 9 How to Use Spray Tips How to Stop Your Electric Pressure Washer The quick–connect on the spray wand allows you The electric pressure washer motor runs only when the to switch between four different quick connect spray trigger is engaged. To stop the electric pressure washer tips.
- Page 10 Applying Detergent Electric Pressure Washer Rinsing 1. Select desired high pressure spray tip following WARNING Chemical Burn Hazard. instructions How to Use Spray Tips. Chemicals could cause burns resulting 2. Keep spray gun a safe distance from area you plan to in death or serious injury.
-
Page 11: Maintenance
Maintenance Check Spray Gun Examine hose connection to spray gun and make sure it General Recommendations is secure. Test trigger (A) by pressing trigger lock button Regular maintenance will improve the performance and (B) and making sure trigger “springs back” into place when extend the life of the electric pressure washer. -
Page 12: Storage
Winter or Long Term Storage 7. Reinstall spray tip into spray wand. 8. Reconnect spray wand to spray gun. Follow steps 1-9 in After Each Use. 9. Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray NOTICE Water left in pump could freeze and permanently gun and pump. -
Page 13: Troubleshooting
Troubleshooting Problem Cause Correction 1. Water inlet is blocked. 1. Clear inlet. 2. Inadequate water supply. 2. Provide adequate water flow. 3. Garden hose is kinked or leaking. 3. Straighten garden hose or replace if Pump has following problems: leaking. failure to produce pressure, 4. -
Page 16: Warranty
BRIGGS & STRATTON RECONDITIONED PRODUCTS WARRANTY POLICY January 2014 LIMITED WARRANTY Briggs & Stratton warrants that, during the warranty period specified below, it will repair or replace, free of charge, any part that is defective in material or workmanship or both. Transportation charges on product submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for and is subject to the time periods and conditions stated below.
Need help?
Do you have a question about the R020802 and is the answer not in the manual?
Questions and answers
I need a replacement for the housing that the high pressure outlet connects to.