Table of Contents
Advertisement
4.
Insert the 3 fasteners through the Handlebar Clamp into the
LeanSteer Frame.
5.
Using the 3mm hex wrench, alternate between the 3 fasteners,
evenly tightening in small increments.
6.
Check to ensure that the gap between the Handlebar Clamp and
the LeanSteer Frame is even, and the same between the top and
bottom. Tighten to 6.0 N-m (4.4 ft-lbf).
16
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PT i2 and is the answer not in the manual?