Connecting The Monitor; Connecting The Spot Monitor; Connecting The Rgb Monitor; Connecting Alarms - Mitsubishi Electric DX-TL4E User Manual

4-channel digital video recorder

Table of Contents

Four-Channel Digital Video Recorder

NOTE: You cannot use spot monitor output and VGA output at the same time.

NOTE: Set the CVBS or VGA selector switch before turning on the DVR. You cannot change

the setting while the unit is running.

Connecting the Monitor

Figure 7 — Video Out connectors.

Connect the SPOT monitor to the Video Out connector.

NOTE: For SPOT monitor Output, set the CVBS/VGA selector switch to the CVBS.

Figure 8 — VGA connector.

A VGA port is provided for RGB monitor output. Connect the RGB monitor to the VGA connector

if required. Connect an RGB cable with a DB-15 (male) connector, which is usually less than 10

feet, to the DVR connector.

NOTE: For RGB monitor output, set the CVBS/VGA selector switch to the VGA.

Figure 9 — Alarm Input connector strips.

NOTE: To make connections on the Alarm Connector Strip, press and hold the button and

insert the wire in the hole below the button. After releasing the button, tug gently on the wire

to make certain it is connected. To disconnect a wire, press and hold the button above the

wire and pull out the wire.

Table of Contents