Connecting The Loop Through Video; Connecting Audio; Setting Unit For Cvbs Or Vga Output; Figure 4 - Video Loop Through Connectors - Mitsubishi Electric DX-TL4E User Manual

User's Manual

Connecting the Loop Through Video

Figure 4 — Video Loop Through connectors.
If you would like to connect your video source to another device, you can use the Loop BNC
connectors.
NOTE: The Loop BNC connectors are auto terminated. Do NOT connect a cable to the Loop
BNC unless it is connected to another terminated device because it will cause poor quality
video.

Connecting Audio

NOTE: It is the user's responsibility to determine if local laws and regulations permit
recording audio.
Figure 5 — Audio In and Out connectors.
Your DVR can record audio. Connect the audio source to Audio In. Connect Audio Out to your
amplifier.
NOTE: The audio input is from an amplified source. The DVR does not have amplified audio
output, so you will need a speaker with an amplifier.

Setting Unit for CVBS or VGA output

Figure 6 — CVBS / VGA switch.
Set the switch to CVBS or VGA for monitor output. Select CVBS for spot monitor, and select
VGA for RGB monitor.
NOTE: The DVR may not support some LCD monitors or some monitors don't support Multi
Sync.
4