Chapter 3 - Configuration; Front Panel Controls; Power Led; Rec Led - Mitsubishi Electric DX-TL4E User Manual

4-channel digital video recorder

Table of Contents

Four-Channel Digital Video Recorder

Chapter 3 — Configuration

NOTE: Your DVR should be completely installed before proceeding. Refer to Chapter 2 —

Installation.

Figure 16 — DVR front panel.

Many of the buttons on the front panel have multiple functions. The following describes each

button and control. Take a few minutes to review the descriptions. You will use these to initially

set up your DVR and for daily operations.

NOTE: A separate Alarm button is not provided. Pressing any keys on the front panel or

remote control resets alarm output including the internal buzzer when the alarm is activated.

However, when you are in the menu or PTZ mode, you have to exit the menu or PTZ mode first

to reset alarm output.

NOTE: The sensor for the infrared remote control is just to the left of the

button. Make

PANIC

certain that nothing blocks the sensor, or the remote control will not function properly.

The POWER LED is lit when the DVR is On.

The REC LED is lit when the DVR is recording. When the DVR is in the panic recording mode,

the REC LED flickers.

The ALARM LED is lit when alarm output or internal buzzer is activated.

Table of Contents