Connections; Connecting Cctv Cameras, Monitors, And Sensors - Mitsubishi Electric DX-TL5716E Installation Manual

Connections

Camera (up to 16 cameras)
RS232C
integral camera
RS422
integral camera
To CAMERA IN
connectors
corresponding to the
camera numbers
Power cord
for the Continent
for U.K
<Cable termination>
Cable end connected to ALARM IN
or I/O terminal and RS485/RS422
5-7 mm strip-off
Applicable wire
0.32-0.65 mm
(AWG 28-22)
24

Connecting CCTV cameras, monitors, and sensors

To OUTPUT A VIDEO or
OUTPUT A S (Y/C) connector
Secure the power cord using the
supplied clamp band to prevent
disconnection. (
Secure the USB cord using the
supplied clamp band to prevent
disconnection. (
To ALARM IN terminals To GND
corresponding to the terminal
sensor numbers
For setting, see
pages 57 and 58.
PTZ control terminals
For setting, see
page 116.
RS422
integral camera
To VIDEO IN or
S(Y/C) IN connector
Page 27)
Page 27)
External recording device
DX-ZD6UE
Up to 8 to 16 devices can be used
at the same time. (The number of
devices differs depending on the
operation manner.)
For setting, see page 38.
RS232C
integral camera
Monitor
Connect either.
To VIDEO IN
connector
To OUTPUT B VIDEO
connector
Monitor
To XGA port
XGA (PC)
monitor
For setting, see
page 111.
To LAN port
To SERIAL
BUS port
Mouse
For setting, see
pages 114 and 115.
For setting, see
page 114.