Table of Contents
Advertisement
User's Manual
Network Setup Screen
In the Network Setup screen you can set up the DVR for LAN and modem connections.
Figure 63 — Network Setup screen.
Highlight the box beside Connection. Press the
button to toggle between LAN and Modem.
Highlight the box beside Admin Password and press the
button. A virtual keyboard appears.
You will first be asked to enter the current password. Then you can enter a new password; you will
be asked to confirm the new password before it is accepted.
Highlight the box beside User Password and press the
button. A virtual keyboard appears.
You will first be asked to enter the current password. Then you can enter a new password; you will
be asked to confirm the new password before it is accepted.
NOTE: These passwords are for network use. They are different from the Admin and User
passwords for the DVR itself.
NOTE: The passwords are case sensitive. The factory default password for both
Administrator and User is 12345678.
CAUTION: Write the password down and keep it in a safe place. Once the
password has been reset, the default will no longer work. If the password is
forgotten, the unit must be reset using the Factory Reset Button and all data
settings will be lost.
The transfer speed is the number of images that can be transferred per second for each camera.
Highlight the box beside Transfer Speed, press the
button, and adjust the number.
NOTE: The maximum transfer speed over a LAN is 25 images per second when the resolution
is set to Standard. However, when set to High, the transfer speed will be decreased to 12.5
images per second.
CAUTION: Selecting the maximum transfer speed will STOP recording video.
Adjust the transfer speed if you want to continue recording.
46
Advertisement
Table of Contents
