T-Box Power Issues - Telstra T-BOX User Manual

t-BoX freezinG
®
• P ress any button on your remote control and observe if the LED on the front of
your T-Box is blinking
• I f the LED is not blinking it could be a remote control related issue.
Call us on 13 2200 for technical support
• I f LED is blinking, try changing channels. Are you able to change channels?
• I f yes, please observe what content is currently freezing. Try putting your T-Box
in deep sleep mode by pressing the power button on the remote for 3 seconds.
Wait until you see a message 'Entering deep sleep mode, please wait'. Wait
for approx. 20 seconds before switching your T-Box on
• C an you access the content now?
• I f no, please call us on 13 2200 for technical support

t-BoX PoWer issUes

• P lease ensure that your T-Box and TV are connected to the power point and
are switched on
• P lease ensure that your T-Box is connected to your TV properly using one
of the cables that came with your T-Box (HDMI is recommended)
• N ow, press the power button on your remote control and check if the LED
on the front of your T-Box is blinking
• I f the LED is not blinking, try replacing the batteries of your remote control
as the batteries may have run out
• A fter replacing the batteries, press the reset button underneath your T-Box
for 2 flashes in order to bring up the remote pairing screen (please refer to
page 43 for details on how to bring up the remote pairing screen)
• P lease follow the on-screen instructions to pair your remote with your T-Box
• I f the LED is blinking and you still don't see anything on your TV screen,
please press the reset button underneath your T-Box for 5 times to perform
a factory reset (please refer to page 43 for details on factory reset)
• I f you are still having problems with powering your T-Box on, please
call us on 13 2200 for further assistance
46