Telstra T-BOX User Manual page 16

Telstra t-box
Hide thumbs Also See for T-BOX:
Table of Contents

Advertisement

let's
Get set
Get ready to be entertained! The Getting Started Guide will help you connect
your T-Box
to your TV aerial cable and TV set. Just follow the on-screen prompts
®
to set up your preferences and BigPond
Once that's done, your T-Box will check for any software updates and install
them for you. Please don't try to use your T-Box until after your T-Box restarts
itself with any new software that might be available. Then you can enjoy all the
very latest features – and everything your T-Box has to offer. But first, here's
some more in-depth information about the steps that you'll go through in the
on-screen instructions.
Please connect your T-Box to your TV as described earlier in this guide and
switch on your T-Box and TV. There's no physical 'on/off' button on the box itself.
Please use the Power button on the top right corner of your remote control.
WARNING: Before disconnecting the power supply, first turn your T-Box off.
Here is how to correctly power off your T-Box:
• P ress the power button on the remote for 3 seconds until you see the on screen
message 'Entering sleep mode; please wait.'
• T hen switch off from the power point. Never pull the cord out of the T-Box directly
as it could cause issues with the hard drive of your T-Box
Pair YoUr t-BoX remote Control to YoUr t-BoX
You need to pair your remote control with your T-Box, to make sure the two
devices are 'talking to each other' properly.
First, check page 11 to make sure you've prepared your remote and activated the
batteries. Then just use your remote control to enter the pairing code shown on
your TV screen.
Re-enter the code when you're asked to, and confirm the connection. It's that easy.
If you ever need to pair your remote control again, refer to page 43 for
instructions on using the Reset Button under your T-Box.
Note: If you've previously used your remote with another T-Box, or you've just
reset your T-Box, you'll need to cancel any previous pairing codes. You can do this
by pressing and holding the remote's 1 and 7 buttons together for 5 seconds.
broadband connection.
®
13

Advertisement

Table of Contents
loading

Table of Contents