Figure 6-8: Fan Tray With Removed Filter - AudioCodes Mediant 1000B Hardware Installation Manual

•
If you are cleaning the filter, use a vacuum cleaner (set to light suction) to remove
dust particles from the filter.
•
If you are replacing the filter, discard the old air filter and replace it with an air filter
purchased from AudioCodes.
5. Attach the (new or cleaned) air filter to the Fan Tray module; position the two holes on
the filter over the pins on the Fan Tray.
6. Insert the Fan Tray module into its slot, until the front panel is flush with the chassis
plate.
7. Fasten the two screws on the top right-hand corner and the bottom right-hand corner
of the front panel of the Fan Tray module.
Hardware Installation Manual

Figure 6-8: Fan Tray with Removed Filter

48
Mediant 1000B Gateway & E-SBC
Document #: LTRT-41401