Replacing I/O Modules On The Front-Panel Slots; Figure 6-5: Removing Amc Modules - AudioCodes Mediant 1000B Hardware Installation Manual

Hardware Installation Manual
4. Using the module handle, pull the module out of the slot (see stage 3 in the figure
below).
6.1.6

Replacing I/O Modules on the Front-Panel Slots

This section describes how to replace front-panel modules. The device's I/O modules are
hot-swappable (except for the OSN Server modules and the CRMX module). The physical
replacement of the I/O modules is done together with a software replacement procedure
using the device's Web interface. Once you have 'software-removed' the module, you can
then physically remove the module and replace it with a new module. Once the new module
is inserted in the chassis slot, you then need to 'software-insert' it.
Warnings:
Note:
Version 6.4

Figure 6-5: Removing AMC Modules

•
Replace the module with the same module type and in the same chassis
slot. For example, a damaged TRUNKS module with two digital spans in
Slot 1 must be replaced with a TRUNKS module with two digital spans in
Slot 1.
•
When only one I/O module is housed in the chassis, the software-
removal procedure is not applicable; instead, power down the device,
physically replace the module, and then power up the device.
For replacing the CRMX module, no software procedure is required (i.e.,
ignore steps 2 and 7 in the procedure below).
45
6. Hardware Maintenance
February 2012